#1 March 7, 2018 17:12:38

prix
Registered: 2015-09-09
Posts: 12
Profile   Send e-mail  

TiWi-BLE .ini files for calibration

Hello,
which .ini file is appropriate for TiWi-BLE to be used during calibration?
WL12xx Calibration guide recommends to use TQS_S_2.6.ini but there are also .ini files from LSR?
I did some diffs between the files and they seems to differ in RefClk=, Single_Dual_Band_Solution=, FEM1_TXBiPReferencePDvoltage_2_4G=, etc?
Autocalibration works with all of them… no apparent differences in wlan operation…
Which one is the correct?
Regards,
Primoz
ps. sorry for TiWi-BLE question in TiWi-SL subforum.

Offline

#2 March 7, 2018 19:16:48

SupportEngineer
Registered: 2016-03-11
Posts: 63
Profile   Send e-mail  

TiWi-BLE .ini files for calibration

Primoz,

Use the ini from the LSR website only. This file is what was used when the module was certified and is required for use in designs that use the TiWi-BLE.

Best Regards,
Laird/LSR

Offline

#3 March 8, 2018 06:49:17

prix
Registered: 2015-09-09
Posts: 12
Profile   Send e-mail  

TiWi-BLE .ini files for calibration

Hi SupportEngineer,

thanks for clarification!

There are two different .INI files on TiWi-BLE product page, ETSI (930-0056) and FCC/IC (930-0005).
Is it OK to use just ETSI (we are from Europe) or must we use FCC/IC when our product is used in USA for example?

Thanks and regards,
Primoz

Offline

#4 March 8, 2018 16:21:41

SupportEngineer
Registered: 2016-03-11
Posts: 63
Profile   Send e-mail  

TiWi-BLE .ini files for calibration

Hello Primoz,

You would use one or the other depending on the country that the radio will operate in. In the US and Canada, the FCC ini file must be used, for Europe and most other countries the ETSI version would be used.

Best Regards,
Laird/LSR

Offline

Board footer

Moderator control