#1 Aug. 27, 2017 14:35:34

uhhhmmm@gmail.com
Registered: 2017-05-01
Posts: 1
Profile   Send e-mail  

Can't sync baud rate when flashing or erasing

I'm receiving this stubborn error in the log when attempting to either erase or flash the bootloader:

Could not sync baud rate!
An error occured trying to erase the flash:
SYNC_BAUD_RATE


I'm using 2 sable-x dev kit boards, central and peripheral. I'm able to flash the peripheral just fine. Just a thought, but perhaps there's some hard reset I might try?

Thanks

Offline

#2 Aug. 28, 2017 20:21:03

jen.gibbs0914@gmail.com
Registered: 2016-02-08
Posts: 1
Profile   Send e-mail  

Can't sync baud rate when flashing or erasing

Have you tried different baud rates to see if it was somehow programmed to a baud rate other than the default 19200?

Thank you,
Jennifer Gibbs

Offline

#3 Sept. 5, 2017 20:08:50

SupportEngineer
Registered: 2016-03-11
Posts: 45
Profile   Send e-mail  

Can't sync baud rate when flashing or erasing

You'll most likely need to use JTAG to reload the Serial-to-BLE FW to the modules.

Offline

Board footer

Moderator control