#1 Oct. 4, 2012 16:10:46

legacyforum
Registered:
Posts: 0
Profile   Send e-mail  

IP address not getting assigned to the TI + CC3000 board

Hi, I am trying to run a basic wi-fi application on LM4f232 board, Texas Instruments. I have downloaded all the drivers and followed the procedure for the 1st time configuration. I am using IAR 6.4 for my application. I can execute 01 command and I can see the message First time configuration done. However when I give 08c0a802a9c0a80201 command, it says done, but I am unable to ping the device, it says target not reachable. 192.168.2.1 is my default gateway, 192.168.2.169 is the IP i want to assign to my module. I have also tried with other IP addresses. I am new to this, and this is my Masters Project. Can you please tell me if there is something else I need to look into or am I missing something? Thanks, Dipti

Edited (Oct. 4, 2012 16:10:46)

Offline

#2 Oct. 4, 2012 16:10:46

legacyforum
Registered:
Posts: 0
Profile   Send e-mail  

IP address not getting assigned to the TI + CC3000 board

Hello Dipti, Have you tried using DHCP? If you use DHCP you can log into the router and see what DHCP addresses have been assigned and also the MAC address. That will tell you if everything is working correctly then. Regards, Ryan

Edited (Oct. 4, 2012 16:10:46)

Offline

#3 Oct. 4, 2012 16:10:46

legacyforum
Registered:
Posts: 0
Profile   Send e-mail  

IP address not getting assigned to the TI + CC3000 board

The module is not being assigned an address. I cannot see it in the assigned devices in DHCP.

Edited (Oct. 4, 2012 16:10:46)

Offline

Board footer

Moderator control