SaBLE-x Porting Instructions for TI BLE Stack
This online guide will walk you through the steps you need to get TI's BLE Stack to run on the SaBLE-x module. Click on Code Composer or IAR below to jump to the instructions.
1Code Composer

1

In Code Composer for the Application project remove the include option for the board file:

2

Remove the board.c file from the project:

3

Navigate to the following path and copy the board.h and board.c files:

4

Paste them in the Application project’s source folder:

5

Add the files to your project:

6

Remove the LCD files:

7

Remove the following pre defines:

8

Remove this call:

9

You should remove any reference to the LCD from your application.

10

If using UART comment out the following line and replace it with the line below:

#if defined(__TI_COMPILER_VERSION__)
#pragma DATA_SECTION(UART_config, ".const:UART_config")
//#pragma DATA_SECTION(uartCC26XXObjects, ".const:uartCC26XXObjects")
#pragma DATA_SECTION(uartCC26XXHWAttrs, ".const:uartCC26XXHWAttrs")
#endif
1IAR

1

In IAR for the Application project remove the include option for the board file:

2

Remove the board.c file from the project:

3

Navigate to the following path and copy the board.h and board.c files:

4

Paste them in the Application project’s source folder:

5

Add the files to your project:

6

Remove the LCD files from your application:

7

Remove the two following preprocessor defines:

8

Comment out the line that opens the LCD in your application:

9

You should remove all references to the LCD in your application.